Removal And Installation Coupe

BODY SIDE TRIM

Removal and Installation


CAUTION:
- Wrap the tip of flat-bladed screwdriver with a cloth when removing metal clips from garnishes.
- When removing, always use Tools made of plastic.
- When removing or installing body side welts, do not allow butyl seal to come in contact with pillar finishers.
- Make sure that clips are fully aligned with panel holes on body when installing, then press them in completely.





- Insert a suitable tool wrapped with a shop cloth inserted into the part shown by the arrow (between the clip and the body side panel), then release the clip.

FRONT PILLAR FINISHER

Removal
1.Partially remove front body side welt.
2.Release the clips, then remove front pillar finisher.
Installation
Installation is in the reverse order of removal.

FRONT KICKING PLATE

Removal
Release the clip and pawls, then remove front kicking plate.
Installation
Installation is in the reverse order of removal.

FRONT BODY SIDE WELT

Removal
1.Remove front kicking plate.
2.Release front body side welt from the body opening, then remove front body side welt.
Installation
Installation is in the reverse order of removal.

REAR PILLAR FINISHER

Removal
1.Release the clips, then remove rear pillar finisher.
2.Remove rear pillar finisher tether bolt.
Installation
Installation is in the reverse order of removal.

REAR LOWER FINISHER

Removal
1.Remove the rear seat back and seat cushion. Coupe.
2.Partially remove front body side welt.
3.Release the clips, then remove rear lower finisher.
Installation
Installation is in the reverse order of removal.

UPPER PILLAR FINISHER

Removal
1.Partially remove front body side welt.
2.Remove rear pillar finisher.
3.Remove seat belt anchor. Removal And Installation
4.Release the clips, then remove upper pillar finisher.
Installation
Installation is in the reverse order of removal.

FRONT SILL PLATE COVER

Removal
Release the pawls, then remove the sill plate cover.
Installation
Installation is in the reverse order of removal.
INT