Control Linkage

CONTROL LINKAGE


Removal and Installation


REMOVAL
1. Remove battery. Removal and Replacement.
2. Remove air cleaner and air duct. Removal And Installation.





3. Remove shift cable from shift lever as shown.





4. Remove select cable from select lever as shown.
5. Move shift selector to neutral position.
6. Remove shift selector handle.
7. Remove center console assembly. Removal And Installation.
8. Remove shift selector assembly nuts.
9. Remove exhaust front tube, center muffler and heat shield. Removal And Installation.
10. Remove cable support bracket.
11. Remove select cable and shift cable from cable bracket.
12. Remove shift selector assembly from the vehicle.

INSTALLATION
Installation is in the reverse order of removal.

NOTE:
Tapping work for tapping bolt is not applied to new clutch housing. Do not perform tapping by other than screwing tapping bolt because tapping is formed by screwing tapping bolt into clutch housing.
- Securely install each cable to shift lever and select lever.





- Be careful about the installation direction, and screw shift selector handle onto shift selector.
Arrow Indicates Front
- When shift selector is selected to 1st-2nd side and 5th-6th side, confirm shift selector returns to neutral position smoothly.
- When shift selector is shifted to each position, make sure there is no binding or disconnection in each boot.