Vehicle Does Not Creep Backward In "R" Position

TROUBLE DIAGNOSIS FOR SYMPTOMS


Vehicle Does Not Creep Backward in "R" Position


SYMPTOM:
Vehicle does not creep backward when selecting "R" position.

DIAGNOSTIC PROCEDURE
1.CHECK SELF-DIAGNOSTIC RESULTS
Perform self-diagnosis check. Refer to CONSULT-III Function (Transmission).
Is any malfunction detected by self-diagnosis
YES >> Check the malfunctioning system. Refer to CONSULT-III Function (Transmission).
NO >> GO TO 2.
2.CHECK CVT POSITION
Check CVT position. Refer to Testing and Inspection.
OK or NG
OK >> GO TO 3.
NG >> Adjust CVT position. Refer to Adjustment Of CVT Position.
3.CHECK CVT FLUID LEVEL
Check CVT fluid level. Refer to .
OK or NG
OK >> GO TO 4.
NG >> Refill CVT fluid.
4.CHECK LINE PRESSURE
Check line pressure at idle. Refer to Inspections Before Trouble Diagnosis.
OK or NG
OK >> GO TO 5.
NG >> Check the malfunctioning item. Refer to Inspections Before Trouble Diagnosis.
5.CHECK STALL REVOLUTION
Check stall revolution. Refer to Inspections Before Trouble Diagnosis.
OK or NG
OK >> GO TO 6.
NG >> Check the malfunctioning item. Refer to Inspections Before Trouble Diagnosis.
6.CHECK SYMPTOM
Check again. Refer to Check At Idle.
OK or NG
OK >> INSPECTION END
NG >> GO TO 7.
7.CHECK TCM
1. Check TCM input/output signals. Refer to TCM Input/Output Signal Reference Value.
2. If NG, re-check TCM pin terminals for damage or loose connection with harness connector.
OK or NG
OK >> Replace the transaxle assembly. Refer to .
NG >> Repair or replace damaged parts.