Removal and Installation

SHIFT CONTROL SYSTEM


Removal and Installation


CONTROL DEVICE COMPONENTS






CONTROL CABLE COMPONENTS






REMOVAL

CAUTION:
Make sure that parking brake is applied before removal and installation.
1. Place the selector lever in the "P" position.
2. Remove the IP center assembly. Refer to Component Parts.
3. Disconnect the CVT device harness connector.
4. Remove the key interlock cable from the control device assembly.
5. Remove the control cable from the control device assembly.
6. Remove the nuts and the control device assembly.

INSTALLATION
Installation is in the reverse order of removal.





- When installing the control cable (3) to the control device assembly (2), make sure that the control cable socket is fully pressed into the control device assembly (2), and the control cable end (1) is fully pressed in with the ribbed surface (A) facing towards the front of the vehicle.
Arrow Indicates Vehicle front
- After installation is completed, adjust and check the CVT position. Refer to Adjustment Of CVT Position and Testing and Inspection.