Cowl Moulding / Trim: Service and Repair

COWL TOP


Removal and Installation







REMOVAL
1. Remove front wiper arm RH/LH. Refer to Service and Repair.





2. Disconnect washer tube.
Arrow Indicates Vehicle front
3. Release the clips and remove cowl top seal.
4. Remove the clips and cowl top cover RH/LH.





5. Disconnect and remove the front wiper motor and linkage assembly. Refer to Service and Repair.

CAUTION:
To avoid damage, make sure to cover the lower edge of windshield with suitable protection material.
6. Remove the bolts and cowl extension panel.

INSTALLATION
Installation is in the reverse order of removal.

NOTE:
- For wiper arm RH/LH installation and adjustment, Refer to Service and Repair.
- Always replace EPT sealer and double-faced adhesive tape when installing cowl top cover.