Rear Drain Hose Installation

REAR DRAIN HOSE INSTALLATION

CAUTION:
- If the rear drain hose is pinched or bent anywhere, the water in the hose may not discharge and enter the inside of the vehicle. During and after installation of the trims and the headliner, always make sure there is no interference with the rear drain hose. Fix any problem if found.

1. Apply soapy water to the rear drain hose inserting area.

2. Insert one end (the wider side) of the rear drain hose into the sunroof frame.

3. Install the rear drain hose to the clips parallel to the pillar and free of slack.

4. Insert the rear drain hose joint into the rear pillar inner hole.

5. Connect the rain sensor connector. (vehicles with rain sensor)

6. Connect the dimming mirror connector. (vehicles with dimming mirror)

7. Install the following parts:
a. Headliner Service and Repair

b. Assist handle Service and Repair

c. Sunvisor Service and Repair

d. Map light Map Light Removal/Installation

e. C-pillar trim C-Pillar Trim Removal/Installation

f. Trunk side upper trim (5HB)

g. Tire house trim Tire House Trim Removal/Installation

h. Rear seat cushion Rear Seat Cushion Removal/Installation

i. B-pillar upper trim B-Pillar Upper Trim Removal/Installation

j. Upper anchor of the front seat belt Front Seat Belt Removal/Installation [Standard Deployment Control System] Front Seat Belt Removal/Installation [Two-Step Deployment Control System]

k. B-pillar lower trim B-Pillar Lower Trim Removal/Installation

l. Rear scuff plate Rear Scuff Plate Removal/Installation

m. Front scuff plate Front Scuff Plate Removal/Installation

n. A-pillar trim A-Pillar Trim Removal/Installation

o. Sunroof seaming welt

8. Install the seaming welt.

9. Connect the negative battery cable. Removal and Replacement Removal and Replacement Removal and Replacement