B-Pillar Upper Trim Removal/Installation

B-PILLAR UPPER TRIM REMOVAL/INSTALLATION

1. Remove the following parts:
a. Adjuster anchor cover Front Seat Belt Removal/Installation [Standard Deployment Control System] Front Seat Belt Removal/Installation [Two-Step Deployment Control System]

b. Upper anchor installation bolts on the front seat belt Front Seat Belt Removal/Installation [Standard Deployment Control System] Front Seat Belt Removal/Installation [Two-Step Deployment Control System]

c. Front scuff plate Front Scuff Plate Removal/Installation

d. Rear scuff plate Rear Scuff Plate Removal/Installation

2. Partially peel back the seaming welt.

3. Remove the B-pillar lower trim. (See B-Pillar Lower Trim Removal/Installation)

4. Grasp the lower end of the B-pillar upper trim, pull it in the direction of the arrow shown in the figure, and remove clips A, pin B, and pin C.






5. Remove the B-pillar upper trim in the direction of the arrow shown in the figure.






CAUTION:
- When removing the B-pillar upper trim, be careful not to damage the tab D.

6. Install in the reverse order of removal.