DTC Inspection - Bluetooth System (Hands-Free Telephone (HF/TEL) System)

DTC INSPECTION [Bluetooth SYSTEM (HANDS-FREE TELEPHONE (HF/TEL) SYSTEM)]

NOTE:
- All DTCs displayed in the DTC inspection should be entered in the Audio Repair Order Form.

Using the M-MDS

1. Connect the M-MDS (IDS) to the DLC-2.






2. After the vehicle is identified, select the following items from the initialization screen of the IDS.

- Select "Self Test".
- Select "Modules".
- Select "ACU".

3. Verify the DTC according to the directions on the screen.

- If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection.

4. After completion of repairs, clear all DTCs stored in the Bluetooth unit. Clearing DTC - Bluetooth System (Hands-Free Telephone (HF/TEL) System)

Without Using M-MDS (On-board Diagnostic Test Mode)

1. Switch the ignition to ACC or ON.

2. While pressing the POWER/VOLUME switch, simultaneously press the PRESET switch 1 and the PRESET switch 6 for 3 s or more.






NOTE:
- If several DTCs are in the memory, they can be displayed using the SEEK/TRACK switch.






3. To stop the on-board diagnostic test mode, ignition is switched to off.