Installation

SUSPENSION: FRONT STABILIZER BAR (for AWD): INSTALLATION

HINT
A bolt without a torque specification is shown in the standard bolt chart Standard Bolt - Specified Torque For Standard Bolts.

1. INSTALL FRONT NO. 1 STABILIZER BAR BUSH

(a) Install the 2 front No. 1 stabilizer bar bushes outside of the bush stoppers on the front stabilizer bar as shown in the illustration.





NOTICE:
Make sure to face the front No. 1 stabilizer bar bush's seam to the lower rear of the vehicle.

2. TEMPORARILY INSTALL FRONT STABILIZER BAR





(a) Temporarily install the front stabilizer bar and front No. 1 stabilizer bracket LH and RH with the 4 bolts in the direction shown in the illustration.

3. INSTALL FRONT NO. 1 STABILIZER BRACKET LH





(a) Install the front No. 1 stabilizer bracket LH with the 2 bolts.

Torque : 95 Nm (969 kgf-cm, 70 ft-lbf)

(b) Install the wire harness bracket with the bolt.

Torque : 22 Nm (224 kgf-cm, 16 ft-lbf)

4. INSTALL FRONT NO. 1 STABILIZER BRACKET RH

(a) Install the front No. 1 stabilizer bracket RH with the 2 bolts.





Torque : 95 Nm (969 kgf-cm, 70 ft-lbf)

5. INSTALL FRONT STABILIZER LINK ASSEMBLY LH





(a) Install the front stabilizer link with the 2 nuts.

Torque : 85 Nm (867 kgf-cm, 63 ft-lbf)

HINT
If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud bolt.

6. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

HINT
Install the RH side following the same procedures as the LH side.

7. INSTALL FRONT LOWER SUSPENSION MEMBER PROTECTOR Installation

8. INSTALL NO. 1 ENGINE UNDER COVER Service and Repair

9. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH Installation

10. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH Installation

11. INSTALL NO. 2 ENGINE UNDER COVER Installation

12. INSTALL FRONT CENTER FLOOR COVER Installation