Removal

SUSPENSION: FRONT UPPER SUSPENSION ARM (for AWD): REMOVAL

NOTICE:
Be sure to read the "PRECAUTION" thoroughly before servicing Suspension Control System.

HINT
* Use the same procedures for the RH side and LH side.
* The procedures listed below are for the LH side.

1. REMOVE COWL TOP VENTILATOR LOUVER RH Removal

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL Removal

3. REMOVE FRONT WHEEL

4. REMOVE FRONT AXLE SHAFT NUT LH Removal

5. DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH Removal

6. REMOVE FRONT DISC Removal

7. REMOVE FRONT DISC BRAKE DUST COVER LH Removal

8. DISCONNECT SKID CONTROL SENSOR WIRE Removal

9. REMOVE FRONT SPEED SENSOR LH Removal

10. DISCONNECT TIE ROD ASSEMBLY LH Removal

11. DISCONNECT FRONT NO. 1 SUSPENSION UPPER ARM ASSEMBLY LH Removal

12. DISCONNECT FRONT NO. 2 SUSPENSION UPPER ARM ASSEMBLY LH Removal

13. REMOVE STEERING KNUCKLE SUB-ASSEMBLY LH Removal

14. DISCONNECT FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH Removal

15. REMOVE FRONT STABILIZER LINK ASSEMBLY LH Removal

16. REMOVE AIR CONNECTOR CLIP HOLDER (w/ Air Suspension) Removal

17. DISCONNECT NO. 4 HEIGHT CONTROL TUBE (w/ Air Suspension) Removal

18. REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY Removal

19. REMOVE ENGINE ROOM SIDE COVER LH Removal

20. REMOVE FRONT SHOCK ABSORBER CAP LH (w/ Air Suspension) Removal

21. REMOVE ABSORBER CONTROL ACTUATOR (w/ Air Suspension) Removal

22. REMOVE FRONT PNEUMATIC SHOCK ABSORBER WITH CYLINDER ASSEMBLY LH (w/ Air Suspension) Removal

23. REMOVE FRONT PNEUMATIC CYLINDER O-RING LH (w/ Air Suspension) Removal

24. REMOVE FRONT SHOCK ABSORBER ASSEMBLY LH (w/o Air Suspension) Removal

25. REMOVE INNER NO. 1 ARM ATTACHMENT PLATE LH

(a) Remove the 3 bolts and inner No. 1 arm attachment plate LH.





26. REMOVE INNER NO. 2 ARM ATTACHMENT PLATE LH

(a) Remove the 2 bolts and inner No. 2 arm attachment plate LH.





27. REMOVE FRONT NO. 1 SUSPENSION UPPER ARM ASSEMBLY LH

(a) Remove the bolt and nut, and then remove the front No. 1 suspension upper arm assembly LH from the inner No. 1 arm attachment plate LH.

28. REMOVE FRONT NO. 2 SUSPENSION UPPER ARM ASSEMBLY LH

(a) Remove the bolt and nut, and then remove the front No. 2 suspension upper arm assembly LH from the inner No. 2 arm attachment plate LH.