Removal

SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY: REMOVAL

HINT
* Use the same procedure for the RH and LH sides.
* The procedure listed below is for the LH side.

1. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY LH Removal

2. REMOVE FRONT SEAT ASSEMBLY LH

(a) Remove the front seat assembly Removal.

3. REMOVE COWL TOP VENTILATOR LOUVER RH Removal

4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
* w/ Navigation System (for HDD):
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal:





* When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

5. REMOVE FRONT DOOR SCUFF PLATE LH Removal

6. REMOVE REAR DOOR SCUFF PLATE LH

(a) for Standard Body:

(1) Remove the rear door scuff plate Removal.

(b) for Long Body:

(1) Remove the rear door scuff plate Removal.

7. REMOVE CENTER LOWER PILLAR GARNISH LH Removal

8. REMOVE CENTER UPPER PILLAR GARNISH LH Removal

9. REMOVE FRONT SEAT SHOULDER BELT GUIDE





(a) Remove the 2 screws and belt guide.

10. REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH





(a) Remove the nut and shoulder anchor.





(b) Disconnect the pretensioner connector as shown in the illustration labeled A.

(c) Disconnect the tension reducer connector labeled B.

(d) w/ Pre-collision system:

Disconnect the pre-collision connector labeled C.





(e) Remove the 2 bolts and seat belt.

11. REMOVE HEIGHT ADJUSTABLE ANCHOR MOTOR LH





(a) Remove the connector.

(b) Pull the motor downward to remove it front the adjuster as shown in the illustration.

12. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY





(a) Remove the 2 bolts and adjuster.