Removal

1UR-FSE EMISSION CONTROL: PURGE VALVE: REMOVAL

1. REMOVE COWL TOP VENTILATOR LOUVER RH Removal

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

3. REMOVE AIR CLEANER INLET COVER Removal

4. REMOVE ENGINE ROOM SIDE COVER LH Removal

5. REMOVE ENGINE ROOM SIDE COVER RH Removal

6. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

7. REMOVE NO. 1 AIR CLEANER INLET Removal

8. REMOVE INTAKE AIR CONNECTOR PIPE Removal

9. REMOVE AIR CLEANER CAP LH

(a) Remove the air cleaner cap LH.

10. REMOVE AIR CLEANER CAP RH

(a) Remove the air cleaner cap RH.

11. DISCONNECT ENGINE WIRE Removal

12. REMOVE PURGE VSV





(a) Disconnect the purge VSV connector.

(b) Disconnect the 2 purge line hoses from the purge VSV.

(c) Remove the bolt and purge VSV.