Installation

ENGINE HOOD / DOOR: HOOD LOCK CONTROL CABLE ASSEMBLY: INSTALLATION

HINT
A bolt without a torque specification is shown in the standard bolt chart Standard Bolt - Specified Torque For Standard Bolts.

1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY

(a) Pass the cable into the engine room.





(b) Pass the cable rear side through the grommet until the cable stopper is attached to the grommet.

(c) Pass the cable front side through the upper radiator support.

(d) Connect the clamps as shown in the illustration.





2. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

(a) Install the hood lock lever and connect the hood lock control cable.





(b) Attach the 2 claws.

3. INSTALL HOOD LOCK ASSEMBLY

(a) Apply MP grease to the sliding areas of the lock.





(b) Connect the hood lock control cable.





(c) Install the hood lock.

(d) Install the 2 bolts and nut.

Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(e) Install a new cap.

4. INSTALL FRONT FENDER PROTECTOR UPPER LH

(a) Attach the 3 clips to install the protector.





5. INSTALL HOOD LOCK CONTROL CABLE COVER

(a) Attach the claw to install the cable cover.





(b) Install the 3 screws.

6. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System) Installation

7. ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System) Adjustments

8. INSTALL RADIATOR GRILLE Installation

9. INSTALL COOL AIR INTAKE DUCT SEAL Installation

10. INSTALL AIR CLEANER INLET COVER SUB-ASSEMBLY Installation

11. INSTALL ENGINE ROOM SIDE COVER RH Installation

12. INSTALL ENGINE ROOM SIDE COVER LH Installation