Installation

AUDIO / VISUAL: STEREO COMPONENT AMPLIFIER: INSTALLATION

HINT
A bolt without a torque specification is shown in the standard bolt chart Standard Bolt - Specified Torque For Standard Bolts.

1. INSTALL NO. 2 AMPLIFIER BRACKET





(a) Set the bracket's aligning protrusions labeled A into the amplifier's holes.

(b) Install the bracket with the 2 screws labeled B.

2. INSTALL NO. 1 AMPLIFIER BRACKET





(a) Set the bracket's aligning protrusions labeled A into the amplifier's holes.

(b) Install the bracket with the 2 screws labeled B.

3. INSTALL STEREO COMPONENT AMPLIFIER ASSEMBLY WITH BRACKET

(a) Install the amplifier with the 4 nuts in the order shown in the illustration.





(b) Connect the connector.

4. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH Installation

5. INSTALL NO. 1 COOLER COVER (w/ Rear Cooler) Installation

6. INSTALL LUGGAGE COMPARTMENT TRIM COVER FRONT Installation

7. INSTALL NO. 2 LUGGAGE COMPARTMENT TRIM HOOK (w/o Rear Cooler) Installation

8. INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY Installation

9. INSTALL REAR FLOOR FINISH PLATE Installation

10. INSTALL DECK TRIM SIDE BOARD RH Installation

11. INSTALL ROPE HOOK ASSEMBLY Installation

12. INSTALL ROPE HOOK Installation

13. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Installation

14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

15. INSTALL COWL TOP VENTILATOR LOUVER RH Installation