Installation

INTERIOR: REAR SUNSHADE ASSEMBLY: INSTALLATION

1. INSTALL REAR SUNSHADE RELAY

NOTICE:
When reassembling the rear sunshade assembly, eliminate static electricity by touching the vehicle body to prevent the components from being damaged.

(a) Install the rear sunshade relay with the 2 screws.





(b) Connect the connector.

(c) Engage the 4 claws and install the rear sunshade relay cover.





(d) Install the screw.

2. INSTALL REAR WINDOW SHADE ASSEMBLY

(a) Install the rear window shade assembly, and temporarily tighten 4 bolts [A] and [B].





(b) Fully tighten the 5 bolts.

(c) Connect the connector.

3. INSTALL NO. 2 PACKAGE TRAY TRIM PANEL ASSEMBLY

(a) Engage the 5 claws and 3 clips, and install the No. 2 package tray trim panel assembly.





4. INSTALL CENTER STOP LIGHT SET Installation

5. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY

(a) Thread the 3 rear seat belt floor anchors into the package tray trim panel assembly.





(b) Insert the rear end of the package tray trim panel assembly into the rear window shade assembly.

(c) Engage the 3 clips and install the package tray trim panel assembly.

(d) Engage the 2 claws and install the rear seat shoulder belt cover.





HINT
Use the same procedure for the other 2 rear seat shoulder belt covers.

(e) Connect the floor side of the rear seat inner with center belt assembly RH with the bolt.





Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)

NOTICE:
Do not allow the anchor part of the rear seat inner with center belt assembly RH and the protruding parts of the floor panel to overlap.

(f) Check if the ELR locks.

NOTICE:
The check should be performed with the outer belt assembly installed.

(1) With the belt assembly installed, check that the belt locks when the belt is pulled out quickly.

(g) Connect the floor side of the rear seat 3 point type belt assembly LH with the bolt.





Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)

NOTICE:
Do not allow the anchor part of the rear seat 3 point type belt assembly LH and the protruding parts of the floor panel to overlap.

HINT
Use the same procedures for the RH side and the LH side.

(h) Check if the ELR locks.

NOTICE:
The check should be performed with the outer belt assembly installed.

(1) With the belt assembly installed, check that the belt locks when the belt is pulled out quickly.

6. INSTALL ROOF SIDE INNER GARNISH LH Installation

7. INSTALL ROOF SIDE INNER GARNISH RH

8. INSTALL REAR SEAT SIDE GARNISH LH Installation

9. INSTALL REAR SEAT SIDE GARNISH RH

10. INSTALL REAR DOOR SCUFF PLATE LH Installation

11. INSTALL REAR DOOR SCUFF PLATE RH

12. INSTALL REAR SEATBACK ASSEMBLY Installation

13. INSTALL REAR CENTER SEAT HEADREST ASSEMBLY

14. INSTALL REAR SEAT HEADREST ASSEMBLY

15. INSTALL REAR SEAT CUSHION ASSEMBLY Installation