Installation

SUPPLEMENTAL RESTRAINT SYSTEM: DRIVER SIDE KNEE AIRBAG ASSEMBLY: INSTALLATION

1. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY

(a) Connect the connector.





NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.

(b) Install the driver side knee airbag assembly with the 4 bolts.

Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Installation

3. INSTALL NO.1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

4. INSTALL SIDE INSTRUMENT PANEL Installation

5. INSTALL FRONT DOOR OPENING TRIM COVER Installation

6. INSTALL FRONT DOOR SCUFF PLATE (w/o Illumination) Installation

7. INSTALL FRONT DOOR SCUFF PLATE (w/ Illumination) Installation

8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

9. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System.