Installation

AUDIO / VISUAL: AMPLIFIER ANTENNA: INSTALLATION

1. INSTALL AMPLIFIER ANTENNA ASSEMBLY

(a) Engage the clip as shown in the illustration to temporarily install the amplifier antenna assembly.





NOTICE:
* Clean the antenna conductors on the rear window with white gasoline where the contact terminals will touch.
* When installing a new amplifier antenna assembly, do not remove the protective cover until immediately before installation.
* Do not touch the contact terminals.

(b) Install the 2 nuts and amplifier antenna assembly.





Torque : 14 Nm (143 kgf-cm, 10 ft-lbf)

(c) Connect the connector.

(d) Engage the clamp.

2. INSTALL ROOF HEADLINING ASSEMBLY

Installation

HINT
Refer to the procedures from "INSTALL ROOF HEADLINING ASSEMBLY".

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

4. INSPECT SRS WARNING LIGHT

Diagnosis System