Installation
SUPPLEMENTAL RESTRAINT SYSTEM: CURTAIN SHIELD AIRBAG ASSEMBLY: INSTALLATION
1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY
(a) Check that the engine switch is off.
(b) Check that the battery negative (-) cable is disconnected.
CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.
(c) Install 4 new clips and 4 new spacers to the curtain shield air bag assembly as shown in the illustration.
NOTICE:
* Do not push in the pin.
* Make sure that the clips are installed in the correct direction.
* Make sure that the spacers are installed properly, in the correct direction, and that they are not damaged.
(d) Install the curtain shield airbag assembly with 5 new bolts.
Torque : 11 Nm (112 kgf-cm, 8 ft-lbf)
NOTICE:
Do not twist the curtain shield airbag assembly when installing it.
(e) Install the 4 clips with the curtain shield airbag assembly to the body panel as shown in the illustration.
NOTICE:
Make sure that the pins of the clips are pushed in firmly.
(f) Mark the clips.
HINT
Mark the clips to make sure that they are not reused.
(g) Connect the curtain shield airbag connector.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.
2. INSTALL ROOF HEADLINING ASSEMBLY (for Standard) Installation
3. INSTALL ROOF HEADLINING ASSEMBLY (for Glass Roof) Installation
4. INSTALL ASSIST GRIP SUB-ASSEMBLY Installation
5. INSTALL INTERIOR ILLUMINATION LIGHT ASSEMBLY (for Standard) Installation
6. INSTALL INTERIOR ILLUMINATION LIGHT ASSEMBLY (for Glass Roof) Installation
7. INSTALL SPOT LIGHT ASSEMBLY LH Installation
8. INSTALL SPOT LIGHT ASSEMBLY RH Installation
9. INSTALL VISOR HOLDER Installation
10. INSTALL VISOR ASSEMBLY LH Installation
11. INSTALL VISOR ASSEMBLY RH Installation
12. INSTALL VISOR BRACKET COVER Installation
13. INSTALL ROOF CONSOLE BOX ASSEMBLY Installation
14. INSTALL RAIN SENSOR COVER Installation
15. INSTALL INNER REAR VIEW MIRROR STAY HOLDER COVER Installation
16. INSTALL FLOOR CARPET BRACKET LH Installation
17. INSTALL FLOOR CARPET BRACKET RH Installation
18. INSTALL SHIFT LEVER ASSEMBLY Installation
19. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY Installation
20. INSTALL NO. 2 CONSOLE BOX DUCT Installation
21. INSTALL NO. 3 CONSOLE BOX DUCT Installation
22. INSTALL REAR CONSOLE BOX ASSEMBLY Installation
23. INSTALL CONSOLE REAR END PANEL SUB-ASSEMBLY Installation
24. INSTALL CONSOLE BOX CARPET Installation
25. INSTALL CONSOLE BOX POCKET Installation
26. INSTALL HEATER SEAT SWITCH CONSOLE BASE (w/o Seat Heater System) Installation
27. INSTALL HEATER SEAT SWITCH CONSOLE BASE (w/ Seat Heater System) Installation
28. INSTALL UPPER CONSOLE PANEL ASSEMBLY WITH FRONT ASH RECEPTACLE Installation
29. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation
30. INSTALL INSTRUMENT PANEL FINISH PANEL END LH Installation
31. INSTALL INSTRUMENT PANEL FINISH PANEL END RH Installation
32. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH Installation
33. INSTALL REAR SEAT SIDE AIRBAG ASSEMBLY LH Installation
34. INSTALL UPPER CENTER PILLAR GARNISH LH Installation
35. INSTALL LOWER CENTER PILLAR GARNISH LH Installation
36. INSTALL REAR DOOR SCUFF PLATE LH Installation
37. INSTALL FRONT PILLAR GARNISH LH Installation
38. INSTALL SIDE INSTRUMENT PANEL LH Installation
39. INSTALL FRONT DOOR OPENING TRIM COVER LH Installation
40. INSTALL FRONT DOOR SCUFF PLATE LH Installation
41. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY RH Installation
42. INSTALL REAR SEAT SIDE AIRBAG ASSEMBLY RH
HINT
Use the same procedure for the RH side and the LH side.
43. INSTALL UPPER CENTER PILLAR GARNISH RH Installation
44. INSTALL LOWER CENTER PILLAR GARNISH RH Installation
45. INSTALL REAR DOOR SCUFF PLATE RH Installation
46. INSTALL FRONT PILLAR GARNISH RH Installation
47. INSTALL SIDE INSTRUMENT PANEL RH Installation
48. INSTALL FRONT DOOR OPENING TRIM COVER RH Installation
49. INSTALL FRONT DOOR SCUFF PLATE RH Installation
50. INSTALL FRONT SEAT ASSEMBLY LH Installation
51. INSTALL FRONT SEAT REAR OUTER TRACK BRACKET COVER LH Installation
52. INSTALL FRONT SEAT REAR INNER TRACK BRACKET COVER LH Installation
53. INSTALL FRONT SEAT OUTER TRACK BRACKET COVER LH Installation
54. INSTALL FRONT SEAT INNER TRACK BRACKET COVER LH Installation
55. CONNECT FRONT SEAT OUTER BELT ASSEMBLY LH Installation
56. INSTALL SEAT BELT ANCHOR COVER CAP LH Installation
57. INSTALL FRONT SEAT HEADREST ASSEMBLY (for Driver Seat)
58. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.
59. INSTALL FRONT SEAT ASSEMBLY RH Installation
60. INSTALL FRONT SEAT REAR OUTER TRACK BRACKET COVER RH Installation
61. INSTALL FRONT SEAT REAR INNER TRACK BRACKET COVER RH Installation
62. INSTALL FRONT SEAT OUTER TRACK BRACKET COVER RH Installation
63. INSTALL FRONT SEAT INNER TRACK BRACKET COVER RH Installation
64. CONNECT FRONT SEAT OUTER BELT ASSEMBLY RH Installation
65. INSTALL SEAT BELT ANCHOR COVER CAP RH Installation
66. INSTALL FRONT SEAT HEADREST ASSEMBLY (for Front Passenger Seat)
67. INSTALL REAR SEATBACK ASSEMBLY Installation
68. INSTALL REAR CENTER SEAT HEADREST ASSEMBLY
69. INSTALL REAR SEAT HEADREST ASSEMBLY
70. INSTALL REAR SEAT CUSHION ASSEMBLY Installation
71. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
HINT
Some systems need initialization after reconnecting the cable to the negative battery terminal.
72. INSPECT SHIFT LEVER POSITION Adjustments
73. ADJUST SHIFT LEVER POSITION Adjustments
74. INSPECT CURTAIN SHIELD AIRBAG ASSEMBLY Curtain Shield Airbag Assembly
75. INSPECT FRONT SEAT ASSEMBLY Installation
76. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light Diagnosis System.