Installation

SUPPLEMENTAL RESTRAINT SYSTEM: REAR SEAT SIDE AIRBAG ASSEMBLY: INSTALLATION

1. INSTALL REAR SEAT SIDE AIRBAG ASSEMBLY

(a) Check that the engine switch is off.

(b) Check that the battery negative (-) cable is disconnected.

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.

(c) Engage the 4 claws.





(d) Install the rear seat side airbag assembly with the 2 bolts.

Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(e) Connect the rear seat side airbag connector.

NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.

2. INSTALL REAR DOOR SCUFF PLATE Installation

3. INSTALL REAR SEATBACK ASSEMBLY Installation

4. INSTALL REAR SEAT CUSHION ASSEMBLY Installation

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

6. PERFORM INITIALIZATION

(a) Perform initialization Repair Instruction - Initialization.

HINT
Some systems need initialization after reconnecting the cable to the negative battery terminal.

7. INSPECT REAR SEAT SIDE AIRBAG ASSEMBLY Rear Seat Side Airbag Assembly

8. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System.