Removal

1UR-FSE IGNITION: IGNITION COIL AND SPARK PLUG: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working Service Precautions.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

3. REMOVE COOL AIR INTAKE DUCT SEAL Removal

4. REMOVE ENGINE ROOM SIDE COVER LH Removal

5. REMOVE ENGINE ROOM SIDE COVER RH Removal

6. REMOVE NO. 1 AIR CLEANER INLET Removal

7. REMOVE AIR CLEANER CAP SUB-ASSEMBLY Removal

8. REMOVE SKID CONTROL ECU Removal

9. REMOVE BATTERY Removal

10. REMOVE NO. 1 BATTERY TRAY SUPPORT

11. REMOVE POWER STEERING ECU ASSEMBLY Removal

12. REMOVE BATTERY TRAY

(a) Remove the 2 bolts and battery tray.





13. SEPARATE NO. 1 ENGINE ROOM RELAY BLOCK ASSEMBLY

(a) Remove the 2 bolts and nut.





14. REMOVE WIRE HARNESS CLAMP BRACKET

(a) Remove the 2 wire harness clamps.





(b) Remove the bolt, wire harness clamp bracket and wire harness clamp.





15. REMOVE IGNITION COIL ASSEMBLY

(a) Disconnect the 8 ignition coil connectors.





(b) Remove the 8 bolts.

(c) Using a screwdriver, pry at the cutouts to remove the 8 ignition coils together with the 8 spark plug tube gaskets.





NOTICE:
Do not damage the cylinder head cover when removing the spark plug tube gasket.

HINT
Tape the screwdriver tip before use.

16. REMOVE SPARK PLUG

(a) Using a 16 mm plug wrench, remove the 8 spark plugs.