Removal

SUPPLEMENTAL RESTRAINT SYSTEMS: CURTAIN SHIELD AIRBAG ASSEMBLY: REMOVAL

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.

1. PRECAUTION

CAUTION:
Be sure to read Precaution thoroughly before servicing Service Precautions.

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Service Precautions.

2. REMOVE ROOF HEADLINING ASSEMBLY

Removal

3. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY

CAUTION:
When storing the curtain shield airbag assembly, keep the airbag deployment side facing upward.

(a) Check that the power switch is off.

(b) Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

(c) Using a screwdriver with the tip wrapped with protective tape, release the airbag connector lock and disconnect the curtain shield airbag connector.





Text in Illustration





NOTICE:
When disconnecting any airbag connector, take care not to damage the airbag wire harness.

(d) Remove the 5 bolts.





(e) Using a clip remover, pull the 4 pins.





Text in Illustration





(f) Using a screwdriver, disengage the 2 claws and separate the clip and curtain shield airbag assembly from the body as shown in the illustration.





Text in Illustration





HINT
Perform the same procedure for the other 3 clips.

(g) Disengage the 5 hooks to remove the curtain shield airbag assembly.





(h) Remove the 4 clips and 4 spacers from the curtain shield airbag assembly.