Removal

2ZR-FXE INTAKE / EXHAUST: INTAKE MANIFOLD: REMOVAL

1. REMOVE THROTTLE BODY ASSEMBLY

Removal

2. REMOVE EGR PIPE ASSEMBLY Removal

3. REMOVE MANIFOLD ABSOLUTE PRESSURE SENSOR Removal

4. REMOVE PURGE VSV Removal

5. REMOVE INTAKE MANIFOLD

(a) Disconnect the 3 connectors and 2 wire harness clamps.





(b) Remove the engine oil level dipstick.

(c) Disconnect the wire harness clamp, and then remove the 2 bolts and engine oil level dipstick guide sub-assembly.





(d) Remove the O-ring from the engine oil level dipstick guide sub-assembly.

(e) Disconnect the fuel vapor feed hose and ventilation hose.





(f) Remove the 2 bolts, 2 nuts and intake manifold.





(g) Remove the No. 1 intake manifold to head gasket.

6. REPLACE STUD BOLT

HINT
If a stud bolt is deformed or the threads are damaged, replace it.

(a) Using an E6 "TORX" socket wrench, replace the 2 stud bolts.





Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)