Installation

PARKING BRAKE: PARKING BRAKE PEDAL: INSTALLATION

1. INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY

(a) Install the parking brake control pedal assembly with the bolt and 2 nuts.

Torque : 15 Nm (148 kgf-cm, 11 ft-lbf)

(b) Connect the parking brake switch connector.

Torque : 15 Nm (148 kgf-cm, 11 ft-lbf)

(e) Engage the cable with the clamp.

(f) Temporarily install the lock nut.

Text in Illustration

HINT
After adjusting parking brake pedal travel, tighten the lock nut.

2. CONNECT NO. 1 PARKING BRAKE PULL ROD SUB-ASSEMBLY

(a) Connect the No. 1 parking brake pull rod sub-assembly to the parking brake control pedal assembly as shown in the illustration.

Text in Illustration

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

3. INSTALL FRONT FLOOR CENTER REINFORCEMENT

(a) Install the front floor center reinforcement with the 4 bolts.

Torque : 27 Nm (275 kgf-cm, 20 ft-lbf)

4. INSTALL YAW RATE AND ACCELERATION SENSOR Installation

5. INSTALL NO. 2 CONSOLE BOX MOUNTING BRACKET

(a) Install the No. 2 console box mounting bracket with the 2 bolts.

(b) Engage the clamp.

6. INSTALL MULTI-MEDIA INTERFACE ECU ASSEMBLY Installation

7. INSTALL NO. 1 ELECTRICAL KEY OSCILLATOR Installation

8. INSTALL MULTI-MEDIA MODULE ASSEMBLY (w/ Navigation System for DVD) Installation

9. INSTALL AIR CONDITIONING UNIT

Installation

10. ADJUST PARKING BRAKE PEDAL TRAVEL Adjustments

11. INSPECT BRAKE WARNING LIGHT Adjustments