Installation

PARKING BRAKE: PARKING BRAKE CABLE: INSTALLATION

1. INSTALL NO. 2 PARKING BRAKE CABLE CLAMP

(a) Engage the 2 claws to install a new No. 2 parking brake cable clamp to the No. 3 parking brake cable assembly.

2. INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY

(a) Install the No. 3 parking brake cable assembly with the 5 bolts.

Torque : 6.0 Nm (61 kgf-cm, 53 in-lbf)

(b) Install the No. 3 parking brake cable assembly to the rear disc brake cylinder assembly.

Text in Illustration

HINT
Be sure to engage the No. 3 parking brake cable assembly clip onto the rear disc brake cylinder assembly as shown in the illustration.

(c) Connect the No. 3 parking brake cable assembly to the rear disc brake cylinder assembly.

(d) Engage the clamp to install the No. 2 parking brake cable clamp.

3. INSTALL PARKING BRAKE LEVER PROTECTOR

(a) Install the parking brake lever protector to the No. 3 parking brake cable assembly.

4. INSTALL REAR FLOOR SIDE MEMBER COVER (w/ Floor Under Cover)

(a) for LH Side:

HINT
Perform the following procedure when installing the No. 3 parking brake cable assembly.

(1) Install the rear floor side member cover LH with the 2 bolts, nut and 2 clips.

(b) for RH Side:

HINT
Perform the following procedure when installing the No. 2 parking brake cable assembly.

(1) Install the rear floor side member cover RH with the bolt, nut and 2 clips.

5. INSTALL FRONT NO. 2 FLOOR HEAT INSULATOR

(a) Install the front No. 2 floor heat insulator with the 3 nuts.

Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)

6. INSTALL FRONT EXHAUST PIPE ASSEMBLY

Installation

7. INSTALL NO. 1 PARKING BRAKE PULL ROD SUB-ASSEMBLY

(a) Connect the No. 3 parking brake cable assembly to the No. 1 parking brake pull rod sub-assembly as shown in the illustration.

Text in Illustration

(b) Connect the No. 2 parking brake cable assembly to the No. 1 parking brake pull rod sub-assembly.

HINT
Perform the same procedure as for the No. 3 parking brake cable assembly.

8. INSTALL NO. 1 PARKING BRAKE CABLE ASSEMBLY

(a) Pass the No. 1 parking brake cable assembly through the parking brake pedal assembly.

(b) Install the clip to the No. 1 parking brake cable assembly.

(d) Temporarily install the adjusting nut.

9. INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY

Installation

10. INSTALL REAR WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)