Removal

PARKING BRAKE: PARKING BRAKE CABLE: REMOVAL

HINT
* Use the same procedures for the No. 2 and No. 3 parking brake cables.
* The procedures listed below are for the No. 1 and No. 3 parking brake cables.
1. FOLLOW PRECAUTION

(a) Follow the precaution Service Precautions.

2. REMOVE FRONT FLOOR BRACE CENTER Removal

3. REMOVE REAR SUSPENSION MEMBER BRACE REAR LOWER LH

4. REMOVE REAR SUSPENSION MEMBER BRACE REAR LOWER RH

5. DISCONNECT HEATED OXYGEN SENSOR Removal

6. REMOVE EXHAUST PIPE ASSEMBLY Removal

7. REMOVE PARKING BRAKE CABLE HEAT INSULATOR Removal

8. REMOVE FRONT FLOOR NO. 1 HEAT INSULATOR Removal

9. DISCONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY Removal

10. DISCONNECT NO. 1 PARKING BRAKE CABLE ASSEMBLY

(a) Remove the 2 bolts and intermediate lever support bracket from the floor panel.





(b) Remove the clip and pin.

(c) Disconnect the cable from the intermediate lever.

11. SET RADIO RECEIVER ASSEMBLY TO SHIPMENT MODE Removal

12. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

13. REMOVE DOOR SCUFF PLATE ASSEMBLY LH Removal

14. REMOVE FRONT DOOR OPENING TRIM COVER LH Removal

15. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY Removal

16. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIR BAG ASSEMBLY Removal

17. REMOVE REAR CONSOLE UPPER PANEL GARNISH Removal

18. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY Removal

19. REMOVE AIR CONDITIONER CONTROL ASSEMBLY Removal

20. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY LOWER CENTER

21. CONFIRM RADIO RECEIVER ASSEMBLY SET TO SHIPMENT MODE Removal

22. REMOVE DOOR SCUFF PLATE ASSEMBLY RH Removal

23. REMOVE FRONT DOOR OPENING TRIM COVER RH Removal

24. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Removal

25. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY Removal

26. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIR BAG ASSEMBLY Removal

27. REMOVE CONSOLE BOX CARPET

28. REMOVE NO. 3 BOX PANEL Removal

29. REMOVE CONSOLE BOX ASSEMBLY Removal

30. REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY Removal

31. REMOVE FLOOR SHIFT ASSEMBLY Removal

32. REMOVE NO. 1 PARKING BRAKE CABLE ASSEMBLY

(a) Remove the 4 nuts, 2 bolts and cable.





33. REMOVE REAR WHEEL

34. DISCONNECT REAR DISC BRAKE CYLINDER ASSEMBLY LH Removal

35. REMOVE REAR DISC Disassembly

36. REMOVE PARKING BRAKE SHOE STRUT LH Disassembly

37. REMOVE PARKING BRAKE SHOE ADJUSTING SCREW SET Disassembly

38. REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY LH Disassembly

39. REMOVE NO. 2 PARKING BRAKE SHOE ASSEMBLY LH Disassembly

40. REMOVE PARKING BRAKE SHOE LEVER LH Disassembly

41. DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY

(a) Remove the 2 bolts, and then disconnect the cable from the backing plate.





42. REMOVE NO. 3 PARKING BRAKE CABLE ASSEMBLY

(a) Remove the 3 bolts and disconnect the cable from the vehicle body.





(b) Disconnect the cable from the clamp.

(c) Disconnect the cable from the intermediate lever, and then remove the cable.

(d) Remove the 2 brackets from the cable.