Initialization

TIRE AND WHEEL: TIRE PRESSURE WARNING SYSTEM: INITIALIZATION

INITIALIZATION

1. DESCRIPTION OF INITIALIZATION
(a) Perform initialization in the following cases:
- Before delivery of a new vehicle.
- After replacement of the tire pressure warning ECU and receiver.*
- After replacement of a tire pressure warning valve and transmitter.*
- When changing the tire inflation pressure by changing traveling speed or load weight, etc.
HINT: *: Perform initialization after the transmitter ID registration is completed Registration.

(b) Before initialization
(1) Set the air pressure of all wheels to the specified values Component Tests and General Diagnostics.
NOTE:
Make sure the tires are cooled down.

2. INITIALIZATION PROCEDURE
(a) Turn the ignition switch ON.





(b) Press and hold the tire pressure warning reset switch for 3 seconds or more so that the tire pressure warning light blinks 3 times.

(c) Turn the ignition switch OFF.
(d) Connect the Techstream to the DLC3.
(e) Turn the ignition switch ON and the Techstream on.
(f) Following the display on the Techstream, select the "Data List"
(g) Read the "ID Tire Inflation Pressure" values.
(h) Check that the initialization has been completed.
(1) Confirm that the tire pressure data of all tires are displayed on the Techstream screen.
NOTICE:
- The initialization is normally completed within 2 to 3 minutes.
- If the initialization has not been completed successfully, DTC C2177/77 is set after approximately 20 minutes or more.
- The initialization can be terminated by connecting terminals 13 (TC) and 4 (CG) of the DLC3.





Tire Pressure Monitor





HINT:
- The initialization is complete when the Data List "ID Tire Inflation Pressure" display shows the correct pressures.
- *: It may take about 2 or 3 minutes until the values are displayed. If the values are not displayed after a few minutes, perform troubleshooting according to the inspection procedure for DTCs C2121/21 to C2124/24 C2121.