Removal

3UZ-FE COOLING: FAN: REMOVAL

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. REMOVE ENGINE UNDER COVER
3. DRAIN ENGINE COOLANT Service and Repair
4. REMOVE NO. 1 AIR CLEANER INLET Removal
5. REMOVE RADIATOR RESERVE TANK ASSEMBLY
(a) Squeeze the clip and remove the reserve tank inlet hose from the radiator assembly.
(b) Remove the 2 bolts and reserve tank.
6. REMOVE INTAKE AIR CONNECTOR PIPE Removal
7. REMOVE AIR CLEANER ASSEMBLY Removal
8. DISCONNECT NO. 1 RADIATOR HOSE Removal
9. REMOVE ENGINE ROOM ECU OUTLET DUCT





(a) Remove the outlet duct.
10. REMOVE FAN SHROUD SUB-ASSEMBLY





(a) Disconnect the 3 clamps and wire harness from the fan shroud.
(b) Disconnect the 2 connectors.





(c) Remove the 6 bolts and fan shroud.
11. REMOVE COOLING FAN ECU





(a) Disconnect the 2 connectors.
(b) Remove the 2 screws and ECU.
12. REMOVE FAN





(a) Remove the 2 nuts and fan.
13. REMOVE COOLING FAN MOTOR
(a) Disconnect the 2 wires from the fan shroud.





(b) Remove the 3 screws and fan motor.
14. REMOVE NO. 2 COOLING FAN MOTOR
(a) Remove the 3 screws and fan motor.