Removal

2GR-FSE COOLING: RADIATOR: REMOVAL

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. REMOVE ENGINE UNDER COVER (for 2WD)
3. REMOVE ENGINE UNDER COVER (for 4WD)
4. DRAIN ENGINE COOLANT Service and Repair
5. REMOVE COOL AIR INTAKE DUCT SEAL Removal
6. REMOVE ENGINE ROOM SIDE COVER RH Removal
7. REMOVE ENGINE ROOM SIDE COVER LH Removal
8. REMOVE V-BANK COVER SUB-ASSEMBLY Removal
9. REMOVE NO. 1 AIR CLEANER INLET Removal
10. REMOVE RADIATOR RESERVOIR ASSEMBLY





(a) Disconnect the reservoir hose from the water inlet.
(b) Remove the 2 bolts, reservoir and grommet.
11. DISCONNECT NO. 1 RADIATOR HOSE
12. DISCONNECT NO. 2 RADIATOR HOSE
13. REMOVE AIR CLEANER ASSEMBLY
(a) Remove the air cleaner cap Removal.
(b) Remove the air cleaner element.
(c) Remove the 3 bolts and air cleaner case.
14. REMOVE ENGINE ROOM ECU OUTLET DUCT
15. REMOVE FRONT BUMPER COVER Removal
16. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System) Removal
17. REMOVE RADIATOR SUPPORT OPENING COVER Removal
18. REMOVE HOOD LOCK CONTROL CABLE COVER Removal
19. REMOVE HOOD LOCK ASSEMBLY Removal
20. REMOVE UPPER RADIATOR SUPPORT SUB-ASSEMBLY Removal
21. REMOVE RADIATOR ASSEMBLY
(a) Disconnect the connector from the cooling fan ECU, and detach the 3 wire harness claws from the fan shroud.





(b) Remove the 4 bolts and radiator.
NOTE:
Do not allow the cooler condenser and radiator to come into contact with each other.





(c) Detach the 3 claws and remove the fan shroud.
(d) Remove the 2 radiator support cushions and 2 radiator lower supports from the radiator.