Removal

DRIVE SHAFT / PROPELLER SHAFT: REAR DRIVE SHAFT ASSEMBLY (for TMC Made): REMOVAL

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.

1. REMOVE REAR AXLE CARRIER SUB-ASSEMBLY

HINT
Refer to the instructions for Removal of the rear axle carrier sub-assembly Removal.

2. DRAIN DIFFERENTIAL OIL Replacement

3. REMOVE REAR DRIVE SHAFT ASSEMBLY

(a) Using SST, remove the rear drive shaft assembly as shown in the illustration.





SST : 09520-00031

SST : 09520-01010

NOTICE:
When removing the rear drive shaft assembly, keep it level.