Removal

2GR-FE ENGINE CONTROL: IGNITION COIL AND SPARK PLUG: REMOVAL

1. PRECAUTION (w/ Navigation System for HDD)

NOTICE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.

2. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

(a) Remove the windshield wiper motor and link assembly Removal.

3. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY Removal

4. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system Service Precautions.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

6. REMOVE NO. 2 AIR CLEANER INLET Removal

7. REMOVE NO. 1 AIR CLEANER INLET Removal

8. REMOVE BATTERY Removal

9. REMOVE NO. 1 ENGINE UNDER COVER

10. DRAIN ENGINE COOLANT Service and Repair

11. REMOVE AIR CLEANER ASSEMBLY Removal

12. REMOVE INTAKE AIR SURGE TANK ASSEMBLY Removal

13. REMOVE NO. 1 SURGE TANK STAY Removal

14. REMOVE IGNITION COIL ASSEMBLY

(a) Disconnect the 3 wire harness clamps.

(b) Disconnect the 6 ignition coil connectors.

15. REMOVE SPARK PLUG

(a) Remove the 6 spark plugs.