A8 Check Switch L2

A8 CHECK SWITCH L2





1. Turn the ignition switch to the OFF position.
2. Disconnect the harness connector.
3. With EM007 disconnected, measure the resistance between EM007/028 and EM007/008.
- With the selector lever at R. N. 3 is the resistance less than 0.5 ohms?
- With the selector lever at P. D, 4, 2 is the resistance greater than 50 K ohms?
Yes --> GO to [A9] A9 Check Switch L3
No --> Inspect EM007 and EM047 for corrosion, bent/pushed back pins or locate and repair the harness EM007/008 to EM047/OOB - test the system for normal operation.

- OK, but fault still present?
Yes --> Renew rotary position switch and test the system for normal operation.