A9 Check Switch L3

A9 CHECK SWITCH L3





1. Turn ignition switch to the OFF position.
2. Disconnect the harness connector.
3. With EM007 disconnected, measure the resistance between EM007/028 and EM007/037.
- With the selector lever at N. D, 4, 3 is the resistance less than 0.5 ohms?
- With the selector lever at P. R. 2 is the resistance greater than 50 K ohms?
Yes --> GO to [A10] A10 Check Switch L4
No --> Inspect EM007 and EM047 for corrosion, bent / pushed back pins or locate and repair the harness EM007/037 to EM047/OOC - test the system for normal operation.

- OK, but fault still present?
Yes --> Renew rotary position switch and test the system for normal operation.