A5 Check D to 4 Switch
CHECK D TO 4 SWITCHNOTE: Engage position 2 firmly.
1. Turn the ignition switch to the OFF position.
2. Disconnect the harness connector.
3. With FC083 disconnected, measure the resistance between switch pins 001 and 003.
- With the selector lever at 4, 3, 2 is the resistance less than 0.5 ohms?
- With the selector lever at P. R. N. D is the resistance greater than less than or greater than 50 K ohms?
Yes --> GO to [A6] A6 Check Harness Digital Ground Continuity
No --> Renew D to 4 switch and test the system for normal operation.