Removal And Installation

REAR COIL SPRING AND SHOCK ABSORBER

Removal and Installation


REMOVAL

1.Perform adjustment before removal. (With 4WAS) Inspection.
2.Remove tires with power tool. Exploded View.
3.Set suitable jack under axle housing.

CAUTION:
Check that jack supporting status is stable.
4.Remove shock absorber from axle housing.
5.Remove the rear parcel shelf finisher. Removal And Installation.
6.Remove the seat belt retractor. Removal And Installation.
7.Remove mounting insulator nuts, and then remove shock absorber assembly.

INSTALLATION

Note the following, and install in the reverse order of removal.
- Perform final tightening of bolts and nuts at the shock absorber lower side (rubber bushing), under unladen conditions with tires on level ground.
- Perform inspection after installation. Inspection.
- After replacing the shock absorber, always follow the disposal procedure to discard the shock absorber.
Disposal.