Removal And Installation

FRONT SEAT BELT

SEAT BELT RETRACTOR : Removal and Installation


REMOVAL


CAUTION:
Before servicing SRS, turn the ignition switch OFF, disconnect battery negative terminal and wait at least 3 minutes.
Seat belt without lap pre-tensioner only
1.Remove the outer anchor.
1.Slide the seat to the foremost position.
2.Remove the outer anchor cover.
3.Remove the mounting anchor bolt of the outer anchor.
2.Remove the shoulder anchor.
1.Remove the front kicking plate inner and rear kicking plate inner. Kicking Plate Inner
2.Remove the center pillar lower garnish. Center Pillar Lower Garnish.
3.Remove the center pillar upper garnish. Center Pillar Upper Garnish.
4.Remove the mounting anchor nut of the shoulder anchor.
3.Remove seat belt pre-tensioner retractor.
1.Disconnect the pre-crash seat belt connector.
2.Disconnect the seat belt pre-tensioner connector.

CAUTION:





- For installing/removing seat belt pre-tensioner connector, insert thin screwdriver wrapped in tape into notch, lift lock and remove connector.


- Install connector with lock raised, and push lock into connector.
- After installing the connector, check that the lock is pushed securely into it.
3.Remove the mounting bolt and mounting anchor bolt of the seat belt pre-tensioner retractor.
4.Remove the seat belt adjuster.
Remove the mounting anchor bolts of the seat belt adjuster.
Seat belt with lap pre-tensioner only
1.Remove the lap pre-tensioner.





1.Insert flat-bladed screwdriver (A) into each hole on lap pretensioner buckle back side, spread the inner metal portion as shown in the figure, and pull out lap pre-tensioner tongue (1) while inserting flat-bladed screwdriver (B) into the hole on lap pre-tensioner buckle.
2.Remove the front kicking plate inner and rear kicking plate inner.
Kicking Plate Inner
3.Remove the center pillar lower garnish.
Center Pillar Lower Garnish.
4.Disconnect the lap pre-tensioner connector.

CAUTION:





- For installing/removing lap pre-tensioner connector, insert thin screwdriver wrapped in tape into notch, lift lock and remove connector.


- Install connector with lock raised, and push lock into connector.
- After installing the connector, check that the lock is pushed securely into it.
5.Remove the mounting anchor bolt of the lap pre-tensioner.
2.Remove the shoulder anchor.
1.Remove the center pillar upper garnish.
Center Pillar Upper Garnish.
2.Remove the mounting anchor nut of the shoulder anchor.
3.Remove seat belt pre-tensioner retractor.
1.Disconnect the pre-crash seat belt connector.
2.Disconnect the seat belt pre-tensioner connector.

CAUTION:





- For installing/removing seat belt pre-tensioner connector, insert thin screwdriver wrapped in tape into notch, lift lock and remove connector.


- Install connector with lock raised, and push lock into connector.
- After installing the connector, check that the lock is pushed securely into it.
3.Remove the mounting bolt and mounting anchor bolt of the seat belt pre-tensioner retractor.
4.Remove the seat belt adjuster.
Remove the mounting anchor bolts of the seat belt adjuster.

INSTALLATION

Install in the reverse order of removal.