Removal And Installation

HOOD LOCK

HOOD LOCK : Removal and Installation


REMOVAL


CAUTION:
Check wiring of hood lock control before removal.
1.Remove air duct (inlet).
- VQ engine models: Exploded View.
- VK engine models: Exploded View.
2.Remove hood lock control cable (front) clips from hood lock stay and condenser upper bracket.
3.Remove hood lock control cable (front) from tube clip of front bumper upper retainer.
4.Remove air cleaner assembly (VK engine models only). Removal And Installation.





5.Remove mounting bolts of hood lock then reward the arrow direction.





6.Disconnect hood lock control cable (front) from hood lock.





7.Disconnect harness connector (A), and then remove hood lock switch harness connector (B) from vehicle.





8.Remove hood lock.

INSTALLATION

Note the following item, and install in the reverse order of removal.

CAUTION:
- Check that hood lock control cable is properly engaged with hood lock.
- After installation, perform hood fitting adjustment. Adjustments.
- After installation, perform hood lock control inspection. Inspection.