Power Steering Pump Replacement

Power Steering Pump Replacement (LLR) (3.7L)

Removal Procedure

1. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement (Service and Repair).
2. Remove the power steering pump pulley. Refer to Power Steering Pump Pulley Replacement (LLR) (Power Steering Pump Pulley Replacement)Power Steering Pump Pulley Replacement (LH8) (Power Steering Pump Pulley Replacement).
3. Disconnect the wiring harness from the power steering fluid reservoir.
4. Remove as much power steering fluid from the power steering fluid reservoir as possible.
5. Place drain pans under the vehicle as needed.




6. Disconnect the power steering gear inlet and outlet hose from the power steering pump and power steering fluid reservoir assembly.




7. Remove the power steering pump bolts.
8. Remove the power steering pump and power steering fluid reservoir assembly from the vehicle.
9. Transfer any parts as needed.

Installation Procedure

1. Install the power steering pump and power steering fluid reservoir assembly to the vehicle.





Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the power steering pump bolts.

Tighten the bolts to 25 Nm (18 lb ft).




3. Connect the power steering gear inlet and outlet hose to the power steering pump and power steering fluid reservoir assembly.

Tighten the fitting to 25 Nm (18 lb ft).

4. Clean any excess power steering fluid from the vehicle and remove the drain pans.
5. Connect the oil pressure sensor wiring harness to the power steering fluid reservoir.
6. Install the power steering pump pulley. Refer to Power Steering Pump Pulley Replacement (LLR) (Power Steering Pump Pulley Replacement)Power Steering Pump Pulley Replacement (LH8) (Power Steering Pump Pulley Replacement).
7. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement (Service and Repair).
8. Fill and bleed the power steering system. Refer to Power Steering System Bleeding (Service and Repair).