Power Steering Pump Pulley Replacement

Power Steering Pump Pulley Replacement (LLR) (3.7L)

Tools Required

* J 25033-C Pulley Installer
* J 25034-C Pulley Remover

Removal Procedure

1. Remove the drive belt. Refer to Drive Belt Replacement (With A/C) (Drive Belt Replacement (With A/C))Drive Belt Replacement (Without A/C) (Drive Belt Replacement (Without A/C)).




2. Remove the power steering pump pulley using remover J 25034-C .




3. Remove the power steering pump pulley from the power steering pump shaft.

Installation Procedure




1. Install the power steering pump pulley to the end of the power steering pump shaft.




2. Install the power steering pump pulley to the power steering pump using installer J 25033-C .




3. Install the power steering pump pulley (1) flush against the end of the power steering pump shaft (2), with an allowable variance of 0.25 mm (0.010 in).
4. Install the drive belt. Refer to Drive Belt Replacement (With A/C) (Drive Belt Replacement (With A/C))Drive Belt Replacement (Without A/C) (Drive Belt Replacement (Without A/C)).