Pinpoint Test AQ: The Memory Feedback Warning Chime Is Inoperative

Instrumentation, Message Center and Warning Chimes

Pinpoint Test AQ: The Memory Feedback Warning Chime Is Inoperative

Normal Operation

The Instrument Panel Cluster (IPC) receives the memory feedback chime request from the Driver Seat Module (DSM) over the Medium Speed Controller Area Network (MS-CAN) communication bus. When a successful memory set procedure is carried out, the DSM (Driver Seat Module) sends a chime request to the IPC (Instrument Panel Cluster) to sound the memory feedback chime.

This pinpoint test is intended to diagnose the following:

- Key-in-ignition warning chime concern

- Memory set feature concern

- DSM (Driver Seat Module)

PINPOINT TEST AQ : THE MEMORY FEEDBACK WARNING CHIME IS INOPERATIVE

AQ1 CHECK THE KEY-IN-IGNITION WARNING CHIME OPERATION

- Ignition OFF.

- On vehicles without Intelligent Access (IA), insert the key into the ignition lock cylinder.

- On vehicles equipped with IA (Intelligent Access), place the ignition in the ACC mode.

- Open the LH front door and observe the key-in-ignition warning chime operation.

Does the key-in-ignition warning chime operate correctly?

Yes
GO to AQ2.

No
GO to Pinpoint Test AK. Pinpoint Test AK: The Key-In-Ignition Warning Chime Is Inoperative

AQ2 CHECK THE MEMORY SET FEATURE

- Verify that the memory set procedure can successfully change the memory preferences.

Does the memory set procedure successfully change the memory preferences?

Yes
GO to AQ3.

No
REFER to Seats.

AQ3 RETRIEVE THE RECORDED DTCs FROM THE IPC (Instrument Panel Cluster) SELF-TEST

- Check for recorded DTCs from the IPC (Instrument Panel Cluster) self-test.

Is DTC U0208:00 recorded?

Yes
GO to Pinpoint Test BB. Pinpoint Test BB: DTC U0208:00

No
INSTALL a new DSM (Driver Seat Module). TEST the system for normal operation.