Selector Lever

Selector Lever









Removal

1. Remove the selector lever bezel. For additional information, refer to Selector Lever Bezel Selector Lever Bezel.

2. Remove the selector lever cable end from the selector lever ball stud.





3. Release the 2 tabs and remove the selector lever cable from the selector lever.





4. Disconnect the selector lever electrical connector.





5. Remove the 4 selector lever bolts and the selector lever from the vehicle.





Installation

1. Install the selector lever and the 4 selector lever bolts.
- Tighten to 12 Nm (106 lb-in).





2. Connect the selector lever electrical connector.





3. Install the selector lever cable on the selector lever housing.
- Be sure the tabs are locked in place.





4. Connect the selector lever cable end on the selector lever ball stud.





5. Install the selector lever bezel. For additional information, refer to Selector Lever Bezel Selector Lever Bezel.

6. Check the selector lever cable adjustment. Make sure that the vehicle starts in PARK and NEUTRAL and the reverse lamps illuminate in REVERSE. If an adjustment is necessary, refer to Selector Lever Cable Adjustment Adjustments.