Selector Lever Bezel

Selector Lever Bezel









Removal

All vehicles

1. Slide the selector lever knob bezel down to access the 2 selector lever knob screws.





2. NOTE: If equipped with a Transmission Control Switch (TCS), do not pull the selector lever knob off of the selector lever.

Remove the 2 selector lever knob screws.





Vehicles equipped with paddle shifters

3. Remove the selector lever knob.

All vehicles

4. Pull up on the 2 center console trim panels and remove the 2 trim panels from the center console. Disconnect the electrical connectors and remove the trim panels.





5. Remove the 4 screws and remove the storage compartment from the center console. Disconnect the lighting electrical connector and remove the storage compartment.





6. Remove the 4 selector lever bezel screws.





7. Position the selector lever bezel and the selector lever knob off of the selector lever and the center console. Disconnect the lighting electrical connector, PRNDL illumination electrical connector and grade assist button electrical connector, if equipped and remove the selector lever knob and bezel.





8. Release the 4 tabs and remove the PRNDL trim ring off of the selector lever bezel.





9. Remove the selector lever boot from the selector lever bezel.





Installation

All vehicles

1. Install the selector lever boot on the selector lever bezel.





2. Install the selector lever trim ring on the selector lever bezel and check that the 4 tabs are latched on the selector lever bezel.





3. If equipped, route the TCS wiring harness through the selector lever bezel. Connect the lighting electrical connector, PRNDL illumination electrical connector and grade assist button electrical connector, if equipped and position the selector lever knob and bezel in place on the selector lever and the center console.





4. Install the 4 selector lever bezel screws.





5. Connect the storage compartment lighting electrical connector, position the storage compartment on the center console and install the 4 screws.





6. Connect the electrical connectors and install the 2 center console trim panels.





Vehicles equipped with paddle shifters

7. Position the selector lever knob on the selector lever.

All vehicles

8. Install the 2 selector lever knob screws.





9. Slide the selector lever knob bezel up and install it on the selector lever bezel knob.