Lumbar Assembly - Power, with Massage

Lumbar Assembly - Power, with Massage

Removal

NOTE: For parts identification and location, refer to Seat - Exploded View, Front Seat - Exploded View, Front.

1. Remove the seat backrest. For additional information, refer to Seat Backrest - Front Seat Backrest - Front.

2. NOTE: Note wire harness and hose routing for installation.

Disengage the backrest cover lower J-clips and route the wire harness(es) and air hoses out of the hole(s) in the backrest cover.





3. On each side, separate the backrest cover clip and hook-and-loop strips.





4. NOTICE: Use care when separating the backrest cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from the backrest foam pad.

Separate the hook-and-loop strips, invert the backrest cover up and remove the 3 first row hog rings.





5. Separate the hook-and-loop strips, invert the backrest cover up and remove the 3 second row hog rings.





6. From the rear of the backrest, disengage the backrest cover J-clip attached to the backrest frame wire.





7. Remove the 2 pin-type retainers at the rear of the backrest foam pad.





8. Pry the upper retainers around the backrest frame wire.





9. Disconnect the electrical connectors, detach the pin-type retainers, disengage the lower retainers and remove the assembly.





Installation

1. Install the lower retainers, connect the electrical connectors and attach the pin-type retainers.

2. Pry both upper retainers around the backrest frame wire.





3. Install the 2 pin-type retainers at the rear of the backrest foam pad.

4. Roll the backrest cover down, attach the hook-and-loop strips and engage the J-clip at the rear to the backrest frame wire.

5. Roll the backrest cover down, attach the hook-and-loop strips and install the 3 second row hog rings.

6. Roll the backrest cover down, attach the hook-and-loop strips and install the 3 first row hog rings.

7. Roll the backrest cover down and attach the hook-and-loop strips.

8. Route the wire harness(es) and air hoses through the hole(s) in the backrest cover and engage the lower J-clips.

9. On each side, wrap the backrest cover around the recliner and attach the hook-and-loop strips and clip.

10. Install the seat backrest. For additional information, refer to Seat Backrest - Front Seat Backrest - Front.