Lumbar Assembly - Power

Lumbar Assembly - Power

Removal

NOTE: For parts identification and location, refer to Seat - Exploded View, Front Seat - Exploded View, Front.

1. Remove the seat backrest. For additional information, refer to Seat Backrest - Front Seat Backrest - Front.

2. NOTE: Note wire harness routing for installation.

Disengage the backrest cover lower J-clips and route the wire harness(es) out of the hole(s) in the backrest cover.





3. On each side, separate the backrest cover clip and hook-and-loop strips.





4. NOTICE: Use care when separating the backrest cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from the backrest foam pad.

Separate the hook-and-loop strips and invert the backrest cover up to the first row of hog rings.

5. If equipped, disconnect the backrest Thermo-Electric Device (TED) electrical connector and disengage the pin-type retainer.





6. Remove the power lumbar.
- Disconnect the motor and disengage the retaining clips.





Installation

1. If equipped, position the TED duct between the power lumbar and cable.





2. Engage the power lumbar retaining clips to the backrest frame and connect the motor.

3. If equipped, connect the backrest TED electrical connector and engage the pin-type retainer.

4. Roll the backrest cover down and attach the hook-and-loop strips.

5. Route the wire harness(es) through the hole(s) in the backrest cover and engage the lower J-clips.

6. On each side, wrap the backrest cover around the recliner and attach the hook-and-loop strips and clip.





7. Install the seat backrest. For additional information, refer to Seat Backrest - Front Seat Backrest - Front.