Pinpoint Test K: DTC U0155

Parking Aid - Explorer

Pinpoint Tests

Pinpoint Test K: DTC U0155

Normal Operation

Several modules receive network messages from the Instrument Cluster (IC) via the Medium Speed Controller Area Network (MS-CAN). The following information is included in the messages:

- Transmission gear selected
- Vehicle speed
- Parking aid disable switch status

As more than one module receives these messages, all modules receiving a particular message should exhibit a symptom if the message is missing.

- DTC U0155 (Lost Communication With Instrument Panel Cluster (IC) Control Panel) - set by the Parking Aid Module (PAM) when network messages are missing from the IC for greater than 5 seconds with the ignition in RUN.

This pinpoint test is intended to diagnose the following:

- Module communication
- PAM
- IC



PINPOINT TEST K: DTC U0155

-------------------------------------------------
K1 VERIFY THE CUSTOMER CONCERN


- Ignition ON.
- Verify that there is an observable symptom present.
- Is an observable symptom present?

Yes
GO to K2.

No
The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

-------------------------------------------------
K2 CHECK THE COMMUNICATION NETWORK


- Ignition ON.
- Enter the following diagnostic mode on the scan tool: Network Test.
- Carry out the network test.
- Does the IC pass the network test?

Yes
GO to K3.

No
REFER to Information Bus.

-------------------------------------------------
K3 RETRIEVE THE RECORDED DTCs FROM THE SELF-TEST


- Check for recorded PAM DTCs from the self-test.
- Is DTC B1317 or DTC B1318 recorded?

Yes
For DTC B1317, GO to Pinpoint Test I. Pinpoint Test I: DTC B1317

For DTC B1318, GO to Pinpoint Test B. Pinpoint Test B: DTC B1318

No
GO to K4.

-------------------------------------------------
K4 RECHECK THE PAM DTCs


NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during Programmable Module Installation (PMI) or the PMI may not have been carried out.

- Clear the DTCs. Repeat the PAM self-test.
- Is DTC U0155 still present?

Yes
GO to K5.

No
The system is operating correctly at this time. The DTC may have been set due to high network traffic.

-------------------------------------------------
K5 CHECK FOR DTC U0155 SET IN OTHER MODULES


- Clear all DTCs.
- Ignition OFF.
- Ignition ON.
- Wait 10 seconds.
- Enter the following diagnostic mode on the scan tool: Self-Test.
- Retrieve the continuous memory DTCs from all modules.
- Is DTC U0155 set in any module?

Yes
INSTALL a new IC. REFER to Instrument Panel, Gauges and Warning Indicators. TEST the system for normal operation.

No
INSTALL a new PAM. REFER to Parking Aid Module (PAM) - Explorer Service and Repair. TEST the system for normal operation.

-------------------------------------------------