Pinpoint Test B: DTC B1318

Parking Aid - Explorer

Pinpoint Tests

Pinpoint Test B: DTC B1318

Refer to Wiring Diagram Set 131, Parking Aid for schematic and connector information. Diagrams By Number

Normal Operation
- DTC B1318 (Battery Voltage Low) - set by the Parking Aid Module (PAM) as a continuous or on-demand DTC when the supply voltage drops below 8 volts for 3 or more seconds during normal operation.

This pinpoint test is intended to diagnose the following:

- Wiring, terminals or connectors
- Charging system concern



PINPOINT TEST B: DTC B1318

NOTICE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the connector.

NOTE: Failure to disconnect the battery when instructed will result in false resistance readings. Refer to Battery.

-------------------------------------------------
B1 CHECK THE PAM VOLTAGE SUPPLY CIRCUIT


- Ignition OFF.
- Disconnect: PAM C4226.
- Ignition ON.
- Measure the voltage between the PAM C4226-18, circuit CBP18 (GY/OG), harness side and ground.




- Is the voltage greater than 10 volts?

Yes
GO to B2.

No
REPAIR the circuit. CLEAR the DTCs. TEST the system for normal operation.

-------------------------------------------------
B2 CHECK THE PAM GROUND CIRCUIT


- Ignition OFF.
- Disconnect: Negative Battery Cable.
- Measure the resistance between the PAM C4226-6, circuit GD145 (BK/BU), harness side and ground.




- Is resistance less than 5 ohms?

Yes
REFER to Charging System to diagnose the low battery voltage concern.

No
REPAIR the circuit. CLEAR the DTCs. TEST the system for normal operation.

-------------------------------------------------