Front Bumper Fascia - Installation

INSTALLATION






NOTE: Base model shown, SRT models similar.

1. With the help of an assistant, position the fascia (2) to the vehicle.
2. Install the eight fascia to radiator support fasteners (1).





3. Align the retaining tabs on the upper fascia (1) with the upper fender retaining bracket. Repeat on the opposite side.
4. Align the retaining tabs on the fascia (2) with the fender retaining bracket located between the bottom corner of the headlamp and the lower front corner of the fender. Repeat on the opposite side.
5. Once aligned, firmly hand tap the fascia (1, 2) to engage the retaining tabs.
6. Install the upper radiator deflectors.
7. Raise and support the vehicle.





8. If equipped, connect the harness (2) to the fog lamps (1).





9. Install the front belly pan (2), Belly Pan - Installation.





10. Install the rear belly pan (2), Belly Pan - Installation.





11. Install the three fasteners (2) that secure each front wheel house splash shield to the front fascia assembly.
12. Install the fastener (1) that secure the front fascia assembly to the fender. Tighten the fastener securely.
13. Lower the vehicle.
14. Connect the negative battery cable.