Steering Wheel Replacement (With SIR)

Steering Wheel Replacement (With SIR)

Tools Required

* J 1859-A Steering Wheel Puller
* J 36541-A Puller Legs
* KM-210-A Steering Wheel Puller

Removal Procedure





Caution: Refer to Battery Disconnect Caution Battery Disconnect Caution.

1. Disconnect the negative battery cable.
2. Remove the SIR module. Refer to Inflatable Restraint Steering Wheel Module Replacement (Except North America Vehicles) Inflatable Restraint Steering Wheel Module Replacement (Except North America Vehicles)Inflatable Restraint Steering Wheel Module Replacement (North America Vehicles) Inflatable Restraint Steering Wheel Module Replacement (North America Vehicles).
3. Remove the steering wheel nut and the retaining clip.





Important: In order to install the steering wheel correctly, match-mark the steering wheel shaft to the steering wheel.


4. Remove the steering wheel using the KM-210-A or the J 1859-A and the J 36541-A (1).
5. Unclip the contact ring from the steering wheel, if necessary.

Installation Procedure




1. Clip the contact ring on the steering wheel, if necessary.

Important: In order to correctly install the steering wheel, match-mark the steering column shaft to the steering wheel.


2. Align the match-marks on the steering wheel and the steering column shaft. Turn the signal cancelling cam on the wheel to the left.

Notice: Refer to Fastener Notice Fastener Notice.

3. Install the retaining clip and the steering wheel nut.

Tighten the steering wheel nut to 38 Nm (20 lb ft).

4. Bend the tabs to secure the retaining clip.
5. Install the SIR module. Refer to Inflatable Restraint Steering Wheel Module Replacement (Except North America Vehicles) Inflatable Restraint Steering Wheel Module Replacement (Except North America Vehicles)Inflatable Restraint Steering Wheel Module Replacement (North America Vehicles) Inflatable Restraint Steering Wheel Module Replacement (North America Vehicles).
6. Connect the negative battery cable.