Ribbed Belt Drive and Accessory Bracket Assembly Overview

Ribbed Belt Drive and Accessory Bracket Assembly Overview






1 Vibration Damper

• With ribbed belt pulley

• Removing and installing, refer to => [ Vibration Damper ] Service and Repair

• Only possible to install in one position

2 Bolt

• Replace

• 10 Nm plus an additional 90° turn

3 Bolt

• 23 Nm

4 Ribbed Belt Tensioning Damper

• Secure with locking pin (T10060 A)

• Removing and installing, refer to => [ Ribbed Belt Tensioner ] Service and Repair

5 Bracket for Assemblies

• Removing and installing, refer to => [ Accessory Assembly Bracket ] Service and Repair

6 Bolt

7 Slide Bushing

8 Generator

• Removing and installing.

9 Bolt

• Insert with locking compound; Locking compound, refer to the electronic parts catalog ETKA.

• Tightening specification and sequence, refer to => [ Accessory Assembly Bracket - Tightening
Specifications and Tightening Sequence ]

10 Bushing

• Quantity: 2

11 Bolt

12 A/C Compressor

13 Ribbed Belt

• Check for wear

• Before removing, mark the direction of rotation using chalk or a felt-tip pen.

• Removing and installing, refer to => [ Ribbed Belt ] Ribbed Belt

• Do not kink

• When installing, make sure it is seated correctly on the ribbed belt pulleys

Accessory Assembly Bracket - Tightening Specifications and Tightening Sequence