Flywheel

Flywheel

Special tools, testers and auxiliary items required

• Extractor (T40176)

• Engine and Transmission Holder (VAS 6095)

• Grease for clutch disc shaft splines (G 000 100)

• Grease Parts Catalog

Removing






• Secure the transmission to the (VAS 6095). Refer to => [ Securing on Engine and Transmission Holder ] Securing On Engine and Transmission Holder.

- Remove the left flange shaft. Refer to => [ Left Flange Shaft ] Left Flange Shaft.

- Attach the (T40176) to the flywheel - A - with nut - B - - arrow -.

- Rotate the (T40176) upward.






• To prevent the flywheel from tilting, counter hold it underneath as illustrated.

- Remove the flywheel from the input shaft - arrow -. Do not tilt the flywheel when doing this.

Installing






Install in reverse order of removal. Note the following:

- Always clean the transmission housing in the area where the differential is accessed - arrow A - and the shaft seal - arrow B -.

• Replace the shaft seal between the differential and transmission housing - arrow B - if it is damaged. Refer to => [ Left Flange Shaft Seal ] Left Flange Shaft Seal.

- Fill the space between the sealing- and dust lip half way with sealing grease; for the correct sealing grease, refer to the Parts Catalog.

- Clean the input shaft - arrow -.






- Lightly grease the input shaft splines with grease for clutch disc shaft splines (G 000 100).

- Slide the clutch module onto the input shaft - arrow - carefully without tilting it.






- Remove the (T40176) from the flywheel - A -.






- Install the left flange shaft. Refer to => [ Left Flange Shaft ] Left Flange Shaft.