Interior CAN Cut Off Connector Mount

Interior CAN Cut Off Connector Mount

Removing






- Disengage the left A-pillar connector station. Refer to => [ Driver Side A-Pillar 6 Pin Connector Station ] Driver Side A-Pillar 6 Pin Connector Station.

- Remove the interior CAN cut off connector (T46i). Refer to => [ Interior CAN Cut Off Connector ] Interior CAN Cut Off Connector.

- Slide the locking lever - 2 - into the "open" position - arrow -.

- Press the release - 1 - and press the mount - 3 - for the interior CAN cut off connector back.

Installing






Install in reverse order of removal, observing the following:

- Slide the locking lever - 1 - on the mount into the "closed" position.

• Both markings - arrows - must align.

- Install the interior CAN cut off connector. Refer to => [ Interior CAN Cut Off Connector ] Interior CAN Cut Off Connector.

- Install the left A-pillar connector station. Refer to => [ Driver Side A-Pillar 6 Pin Connector Station ] Driver Side A-Pillar 6 Pin Connector Station.